Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 96)

Table 33: 1-Port SFP Mini-PIM LED States

DescriptionStateColorLED

Port is onlineOnGreenLINK

Port is offlineOff

Port is receiving or sending dataBlinkingGreenACT

Port might be on but is not receiving or

sending data

Off

Documentation

1-Port SFP Mini-Physical Interface Module Overview on page 73•

• 1-Port SFP Mini-Physical Interface Module Hardware Specifications on page 74

• 1-Port SFP Mini-Physical Interface Module Network Interface Specifications on page 74

• 1-Port SFP Mini-Physical Interface Module Supported Modules on page 75

• 1-Port SFP Mini-Physical Interface Module Key Features on page 76

• 1-Port SFP Mini-Physical Interface Module Basic Configuration on page 78

1-Port SFP Mini-Physical Interface Module Basic Configuration

To enable the 1-Port Small Form-Factor Pluggable Mini-Physical Interface Module (SFP

Mini-PIM) installed on the SRX Series Services Gateway, you must configure the properties.

You can perform the same configuration tasks using either the J-Web interface or the

CLI. In addition, you can configure a wide variety of options that are not encountered

frequently.

•

Using the J-Web Interface on page 78

•

Using the CLI on page 79

Using the J-Web Interface

To perform basic configuration of the 1-Port SFP Mini-PIM and to configure network

interfaces for the services gateway using the J-Web interface:

1. In the J-Web interface, select Configure>Interfaces>Ports.

The Interfaces page displays and lists the network interfaces present on the services

gateway, along with configuration information (if configured).

2. To configure properties for a network interface (Mini-PIM), select the interface name,

and click Edit.

SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 96