Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 105)

c. For host inbound traffic, set the following:

•

System Services=Allow All

•

Protocols=Allow All

d. Click OK to save changes, and click Commit to apply the configuration and other

pending changes (if any).

4. To use the port on the Mini-PIM, you must also set security policies. Select the following

settings:

a. Select Configure>Security>Policy>Apply Policy.

b. Set Policy Action: Default Policy Action=Permit-All.

c. Click OK to save changes, and click Commit to apply the configuration and other

pending changes (if any).

For advanced configuration information, see the Junos OS Network Interfaces

Configuration Guide.

Using the CLI

To perform basic configuration for the 1-Port T1/E1 Mini-PIM (for the T1 interface) and to

configure network interfaces for the services gateway with the CLI:

•

Verify that the T1/E1 interface is installed on the device:

show chassis hardware

•

Verify the status of the interface:

show interfaces terse

•

Assign the port an IP address:

For T1 interfaces:

set interfaces t1-1/0/0 unit 0 family inet address interface address/destination prefix

For E1 interfaces:

set interfaces e1-1/0/0 unit 0 family inet address interface address/destination prefix

•

Add or select a security zone; for example, Trust:

For T1 interfaces:

set security zones security-zone trust interfaces t1-1/0/0.0 host-inbound-traffic

system-services all

For E1 interfaces:

set security zones security-zone trust interfaces e1-1/0/0.0 host-inbound-traffic

system-services all

•

Add or select security zones for host inbound traffic protocol options:

For T1 interfaces:

Chapter 9: 1-Port T1/E1 Mini-Physical Interface Module

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 105