Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 95)

•

1000BASE-LH (ZX)

•

Tri-Rate 10/100/1000BASE-T, Copper Transceiver

•

1000BASE-BX10, at 10 km (TX1310 nm / RX1490 nm)

•

1000BASE-BX10, at 10 km (TX1310 nm / RX1550 nm)

•

1000BASE-BX10, at 10 km (TX1490 nm / RX1310 nm)

•

1000BASE-BX10, at 10 km (TX1550 nm / RX1310 nm)

•

1000BASE-BX, at 40 km (TX1310 nm / 1550 nm)

•

1000BASE-BX, at 40km (TX1550 LC nm / RX1310 nm)

•

100Base-BX Fast Ethernet Optics, at 20 km (TX 1310 nm / RX 1550 nm)

•

100Base-BX Fast Ethernet Optics, at 20 km (TX 1550 nm / RX 1310 nm)

NOTE: The 1-Port SFP Mini-PIM with Ethernetconnector provides 1000-Mbps

link speed. Actual bandwidth is limited to 100 Mbps.

NOTE: We strongly recommend the use of Juniper Networks SFP and XFP

transceivers. We cannot guarantee correct operation if other transceivers are

used. The transceiver type can be different in each port, as long as a supported

part number is used.

Documentation

1-Port SFP Mini-Physical Interface Module Overview on page 73•

• 1-Port SFP Mini-Physical Interface Module Hardware Specifications on page 74

• 1-Port SFP Mini-Physical Interface Module Network Interface Specifications on page 74

• 1-Port SFP Mini-Physical Interface Module LEDs on page 77

• 1-Port SFP Mini-Physical Interface Module Basic Configuration on page 78

1-Port SFP Mini-Physical Interface Module LEDs

The 1-Port Small Form-Factor Pluggable Mini-Physical Interface Module (SFP Mini-PIM)

has two LEDs located to the right of the socket. Table 33 on page 78 describes the LED

states.

Chapter 8: 1-Port SFP Mini-Physical Interface Module

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 95