Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 48)

7. Grasp the handles on each side of the GPIM faceplate, and slide the GPIM out of the

services gateway.

8. Place the GPIM in an electrostatic bag or on an antistatic mat.

9. If you are not reinstalling a GPIM into an empty slot, install a blank GPIM faceplate

over the empty slot to maintain proper airflow. If you are reinstalling another GPIM

into the empty slot, see “Installing a Gigabit-Backplane Physical Interface Module on

the SRX Series Services Gateway” on page 24.

NOTE: When installing a blankGPIM faceplate, make sure that the padded

side of the faceplate is facing up.

Documentation

• Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate from the

SRX Series Services Gateway on page 24

• Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services

Gateway on page 24

• Required Tools and Parts for Replacing a Gigabit-Backplane Physical Interface Module

on page 22

SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 48