Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 46)

Figure 12: GPIM Slot Bracket

g032722

650

4. To continue with the GPIM installation, see “Installing a Gigabit-Backplane Physical

Interface Module on the SRX Series Services Gateway” on page 24.

CAUTION: If you remove a double-high,double-wide GPIM, you should replace

the bracket before you install blank faceplates or other GPIMs. This is

important for maintaining radio frequency compliance.

Documentation

Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate from the

SRX Series Services Gateway on page 24

•

• Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services

Gateway on page 24

• Removing a Gigabit-Backplane Physical Interface Module from the SRX Series Services

Gateway on page 28

• Required Tools and Parts for Replacing a Gigabit-Backplane Physical Interface Module

on page 22

Removing a Gigabit-Backplane Physical Interface Module from the SRX Series Services Gateway

CAUTION: Only SRX650 Services Gateway supports hot-swappable

functionality for GPIMs.

SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 46