Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 136)

NOTE: The interface xe-6/0/0 is the correct configuration if the 2-Port 10

Gigabit Ethernet XPIM is installed in slot 6. If the 2-Port 10 Gigabit Ethernet

XPIM is installed in slot 2 (valid only on SRX650), then the correct interface

configuration would be xe-2/0/0

•

Assign MTU values:

set interfaces xe-6/0/0 unit 0 family inet mtu mtu values

•

Set link options:

set interfaces xe-6/0/0 gigether-options802.3ad/auto-negotiation/ loopback

•

Add or select a security zone; for example, Trust:

set security zones security-zone trust interfaces xe-6/0/0.0 host-inbound-traffic

system-services all

•

Add or select security zones for host inbound traffic:

set security zones security-zone trust interfaces xe-6/0/0.0 host-inbound-trafficprotocols

all

•

Set security policies:

set security policies default-policy permit-all

•

Set operating mode, for example, copper:

set interfaces xe-6/0/0 media-type copper

NOTE: By default, interfaces run in fiber mode at 10 G speed with

autonegotiation.

•

Set interface speed, for example, 10 G:

set interfaces xe-6/0/0 speed 10g

NOTE: For copper ports, all 10 Mbps, 100 Mbps, 1 G, and 10 G speeds are

supported; for fiber ports, only 1 G and 10 G speeds are supported.

Documentation

• 2-Port 10 Gigabit Ethernet XPIM Overview on page 109

• 2-Port 10 Gigabit Ethernet XPIM Key Features on page 110

• 2-Port 10 Gigabit Ethernet XPIM Hardware Specifications on page 111

• 2-Port 10 Gigabit Ethernet XPIM LEDs on page 113

• 2-Port 10 Gigabit Ethernet XPIM Components on page 114

• Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services

Gateway on page 24

SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 136