Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 39)

To remove a Mini-PIM from the SRX Series Services Gateway:

1. Place an electrostatic bag or antistatic mat on a flat, stable surface on which you

intend to place the Mini-PIM.

2. Attach an ESD grounding strap to your bare wrist, and connect the strap to the

grounding point on the back of the device.

3. Unplug the power adapter from the device. Verify that the Power LED is off.

4. Label the cables connected to the Mini-PIM so that you can later reconnect each

cable to the correct Mini-PIM.

5. Disconnect the cables from the Mini-PIM.

6. If necessary, arrange the cables to prevent them from dislodging or developing stress

points.

7. Remove the screws on each side of the Mini-PIM faceplate using a screwdriver.

8. Grasp the screws on each side of the Mini-PIM faceplate and slide the Mini-PIM out

of the device. See Figure 8 on page 21.

Figure 8: Removing a Mini-PIM from the SRX Series Services Gateway

9. Place the Mini-PIM in the electrostatic bag or on the antistatic mat.

10. If you are not reinstalling a Mini-PIM into the empty slot, install a blank faceplate over

the slot to maintain proper airflow.

NOTE: When installing a blank Mini-PIM faceplate, makesurethat the padded

side of the faceplate is facing up.

Documentation

Required Tools and Parts for Replacing a Mini-Physical Interface Module on page 17•

• Removing a Blank Mini-Physical Interface Module Faceplate from the SRX Series

Services Gateway on page 18

• Installing a Mini-Physical Interface Module in the SRX Series Services Gateway on

page 19

• SRX Series Services Gateway Mini-Physical Interface Modules Overview on page 4

Chapter 2: Installing and Removing Interfaces on the SRX Series Services Gateway

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 39