Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 89)

Using the J-Web Interface

To perform basic configuration of the 1-Port Serial Mini-PIM and to configure network

interfaces for the services gateway using the J-Web interface:

1. In the J-Web interface, select Configure>Interfaces>Ports.

The Interfaces page displays and lists the network interfaces present on the services

gateway, along with configuration information (if configured).

2. To configure properties for a network interface (Mini-PIM), select the interface name

(se-1/0/0), and click Edit.

3. To use the port on the Mini-PIM, you must assign it to a security zone other than the

Null zone. Optionally, you can also assign the port an IP address (for example,

192.168.3.1/24). Enter or select the following settings:

a. Select Configure>Security>Zones.

b. Add or select a security zone other than Null; for example, Trust

c. For host inbound traffic, set the following:

•

System Services=Allow All

•

Protocols=Allow All

d. Click OK to save changes, and click Commit to apply the configuration and other

pending changes (if any).

4. To use the port on the Mini-PIM, you must also set security policies. Select the following

settings:

a. Select Configure>Security>Policy>Apply Policy.

b. Set Policy Action: Default Policy Action=Permit-All.

c. Click OK to save changes, and click Commit to apply the configuration and other

pending changes (if any).

For advanced configuration information, see the Junos OS Network Interfaces

Configuration Guide.

Using the CLI

To perform basic configuration for the 1-Port Serial Mini-PIM and to configure network

interfaces for the services gateway with the CLI:

•

Verify that the serial interface is installed on the device:

show chassis hardware

•

Verify the status of the interface:

show interfaces terse

•

Assign the port an IP address:

Chapter 7: 1-Port Serial Mini-Physical Interface Module

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 89