Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 42)

Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate from the SRX Series

Services Gateway

To maintain proper airflow through the services gateway, leave blank faceplates in place

over slots that do not contain Gigabit-Backplane Physical Interface Modules (GPIMs).

Do not remove a blank faceplate unless you are installing a GPIM in the empty slot.

To remove a blank faceplate:

1. Using a Phillips (+) screwdriver, loosen the captive screws on each side of the blank

faceplate.

2. Using a flat-blade (–) screwdriver, gently pry out one side of the faceplate and pull

it off.

NOTE: When installing a blank GPIM faceplate, make sure that the padded

side of the faceplate is facing up.

Documentation

Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services

Gateway on page 24

•

• Installing a Double-High, Double-Wide Gigabit-Backplane Physical Interface Module

on the SRX Series Services Gateway on page 27

• Removing a Gigabit-Backplane Physical Interface Module from the SRX Series Services

Gateway on page 28

• Required Tools and Parts for Replacing a Gigabit-Backplane Physical Interface Module

on page 22

Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services Gateway

NOTE: Only SRX650Services Gatewaysupportshot-swappable functionality

for GPIMs. Ensure that the GPIM is installed in the appropriate GPIM slot. For

more information about the appropriate GPIM slots, see “SRX Series Services

Gateway Gigabit-Backplane Physical Interface Modules Overview” on page 5.

SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 42