Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 82)

• 1-Port G.SHDSL 8-Wire Mini-Physical Interface Modules Basic Configuration on page 64

1-Port G.SHDSL 8-Wire Mini-Physical Interface Modules Basic Configuration

To enable the 1-Port G.SHDSL 8-Wire Mini-Physical Interface Module (Mini-PIM) installed

on the SRX Series Services Gateway, you must configure its properties. You can perform

the same configuration tasks using either the J-Web interface or the CLI. In addition, you

can configure a wide variety of options that are not encountered frequently.

•

Using the J-Web Interface on page 64

•

Using the CLI on page 65

Using the J-Web Interface

To perform basic configuration for the 1-Port G.SHDSL 8-Wire Mini-PIM and to configure

network interfaces for the services gateway using the J-Web interface:

1. In the J-Web interface, select Configure>Interfaces>Ports.

The Interfaces page displays and lists the network interfaces present on the services

gateway, along with configuration information (if configured).

2. To configure properties for a network interface (Mini-PIM), select the interface name

(at-1/0/0), and click Edit.

3. To use the port on the Mini-PIM, you must assign it to a security zone other than the

Null zone. Optionally, you can also assign the port an IP address (for example,

192.168.3.1/24). Enter or select the following settings:

a. Select Configure>Security>Zones.

b. Add or select a security zone other than Null; for example, Trust.

c. For host inbound traffic, set the following:

•

System Services=Allow All

•

Protocols=Allow All

d. Click OK to save changes, and click Commit to apply the configuration and other

pending changes.

4. To use the port on the Mini-PIM, you must also set security policies. Select the following

settings:

a. Select Configure>Security>Policy>Apply Policy.

b. Set Policy Action: Default Policy Action=Permit-All.

c. Click OK to save changes, and click Commit to apply the configuration and other

pending changes (if any).

For more information, in the J-Web interface, select Configure>Interfaces and click

Help.

SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 82