Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 38)

Figure 7: Installing a Mini-PIM in an SRX Series Services Gateway

7. Using a 1/8-in. (3-mm) flat-blade (–) screwdriver, tighten the screws on each side of

the Mini-PIM faceplate.

8. Insert the appropriate cables into the cable connectors on the Mini-PIM.

9. If necessary, arrange the cables to prevent them from dislodging or developing stress

points:

•

Secure the cables so that they are not supporting their own weight as they hang to

the floor.

•

Place any excess cables out of the way in neatly coiled loops.

•

Use fasteners to maintain the shape of the cable loops.

10. Reconnect the power adapter to the device. Verify that the Power LED glows steadily

green after you press the power button.

11. Verify that the Mini-PIM LED on the system dashboard glows steadily green to confirm

that the Mini-PIM is online.

Documentation

Required Tools and Parts for Replacing a Mini-Physical Interface Module on page 17•

• Removing a Mini-Physical Interface Module from the SRX Series Services Gateway on

page 20

• Removing a Blank Mini-Physical Interface Module Faceplate from the SRX Series

Services Gateway on page 18

• SRX Series Services Gateway Mini-Physical Interface Modules Overview on page 4

Removing a Mini-Physical Interface Module from the SRX Series Services Gateway

CAUTION: The Mini-PIMs available on the SRX Series Services Gateway are

not hot-swappable. You must power off the device before removing or

installing Mini-PIMs.

SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 38