The 2-Port 10 Gigabit Ethernet XPIM contains two 10 Gigabit Ethernet interfaces with
both copper and small form-factor pluggable plus transceiver (SFP+) terminations, to
support redundancy and enable the services gateway ateway to be used as a pure security
service device. The 2-Port 10 Gigabit Ethernet XPIM also provides effective MPLS/GRE
termination of customer traffic with reasonable performance.
NOTE: Only SRX650 Services Gateway supports hot-swappable functionality
for GPIMs.
Figure 27 on page 110 shows the 2-Port 10 Gigabit Ethernet XPIM.
Figure 27: 2-Port 10 Gigabit Ethernet XPIM
Related
Documentation
2-Port 10 Gigabit Ethernet XPIM Key Features on page 110•
• 2-Port 10 Gigabit Ethernet XPIM Hardware Specifications on page 111
• 2-Port 10 Gigabit Ethernet XPIM LEDs on page 113
• 2-Port 10 Gigabit Ethernet XPIM Components on page 114
• 2-Port 10 Gigabit Ethernet XPIM Basic Configuration on page 115
• Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services
Gateway on page 24
2-Port 10 Gigabit Ethernet XPIM Key Features
The 2-Port 10 Gigabit Ethernet XPIM supports the following key features:
•
Contains a total of four ports:
•
Two SFP+ fiber ports
•
Two 10 G Base-T copper ports
Only two of the four ports can be active at the same time (one from port group 0 and
one from port group 1). Mixing and matching between the copper and fiber port types
is supported.
•
Receives SFP+ optics and, at a minimum, supports these SFP+ transceivers:
•
SFPP-10GE-SR
•
SFPP-10GE-LR
•
SFPP-10GE-ER
•
SFPP-10GE-LRM
•
Copper Twin-AX 1m
Copyright © 2012, Juniper Networks, Inc.110
SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide
Commentaires sur ces manuels