Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 181)

c. Click OK to save changes, and click Commit to apply the configuration and other

pending changes (if any).

For advanced configuration information, see the Junos OS Network Interfaces Configuration

Guide.

Using the CLI to Configure the CT1 Interface

To perform basic configuration for the Quad CT1/E1 GPIM (for the CT1 interface) and to

configure network interfaces for the services gateway with the CLI:

NOTE: You must configure the parent CT1 interface before you can configure

the child T1 interface.

•

Verify that the Quad CT1/E1 GPIM is installed on the services gateway:

show chassis hardware

•

Verify the FPC status of the interface:

show chassis fpc

•

Configure the parent CT1 interface with no partitioning:

set interfaces ct1-1/0/0 no-partition interface-type t1

•

Configure the child T1 interface and assign an IP address:

set interfaces t1-1/0/0 unit 0 family inet address ip4–address/prefix

•

Assign MTU values to the child T1 interface:

set interfaces t1-1/0/0 unit 0 mtu mtu values

•

Configure a security zone for the child T1 interface and set the configuration for host

inbound traffic services and protocols:

set security zones security-zone trust interfaces t1-1/0/0 host-inbound-traffic

system-services all

set security zones security-zone trust interfaces t1-1/0/0 host-inbound-traffic protocols

all

•

Set security policies:

set security policies default-policy permit-all

Using the CLI to Configure the CE1 Interface

To perform basic configuration for the Quad CT1/E1 GPIM (for the CE1 interface) and to

configure network interfaces for the services gateway with the CLI:

NOTE: You must configure the parent CE1 interface before you can configure

the child E1 interface.

Chapter 17: Quad CT1/E1 GPIM

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 181