Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 112)

c. Click OK to save changes, and click Commit to apply the configuration and other

pending changes (if any).

For more information, in the J-Web interface, select Configure>Interfaces and click Help.

Using the CLI

To perform basic configuration of the 1-Port VDSL2 (Annex A) Mini-PIM and to configure

network interfaces for the services gateway with the CLI:

•

Verify that the 1-Port VDSL2 interface is installed on the device:

show chassis hardware

•

Verify the status of the interface:

show interfaces terse

•

Assign the port an IP address:

set interfaces pt-1/0/0 unit 0 family inet address interface address/destination prefix

•

Add or select a security zone; for example, Zone1:

set security zones security-zone trust interfaces pt-1/0/0.0 host-inbound-traffic

system-services all

•

Add or select security zones for host inbound traffic options protocols:

set security zones security-zone trust interfaces pt-1/0/0.0 host-inbound-traffic protocols

all

•

Set security policies:

set security policies default-policy permit-all

See the Junos OS Network Interfaces Configuration Guide for more details.

Documentation

• 1-Port VDSL2 (Annex A) Mini-Physical Interface Module Overview on page 89

• 1-Port VDSL2 (Annex A) Mini-Physical Interface Module Key Features on page 90

• 1-Port VDSL2 (Annex A) Mini-Physical Interface Module Supported Profiles on page 91

• 1-Port VDSL2 (Annex A) Mini-Physical Interface Module Hardware Specifications on

page 91

• 1-Port VDSL2 (Annex A) Mini-Physical Interface Module Cable Specifications on page 192

SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 112