Juniper 1-Port Serial Mini-PIM Spécifications télécharger pdf (Page 165)

Using the CLI

To perform basic configuration for the 24-Port Gigabit Ethernet XPIM and to configure

network interfaces for the services gateway with the CLI:

•

Verify that the 24-Port Gigabit Ethernet XPIM is installed on the services gateway:

show chassis hardware

•

Verify the FPC status of the interface:

show chassis fpc

•

Assign the port an IP address:

set interfaces ge-2/0/0 unit 0 family inet address interface address/destination prefix

•

Assign MTU values:

set interfaces ge-2/0/0 unit 0 family inet mtu mtu values

•

Set link options:

set interfaces ge-2/0/0 gigether-options auto-negotiation

•

Add or select a security zone; for example, Trust:

set security zones security-zone trust interfaces ge-2/0/0.0 host-inbound-traffic

system-services all

•

Add or select security zones for host inbound traffic:

set security zones security-zone trust interfaces ge-2/0/0.0 host-inbound-traffic protocols

all

•

Set security policies:

set security policies default-policy permit-all

Documentation

• SRX Series Services Gateways Interfaces Port Naming Conventions on page 13

• 24-Port Gigabit Ethernet XPIM Overview on page 139

• 24-Port Gigabit Ethernet XPIM Key Features on page 140

• 24-Port Gigabit Ethernet XPIM Hardware Specifications on page 141

• 24-Port Gigabit Ethernet XPIM LEDs on page 142

• 24-Port Gigabit Ethernet XPIM Components on page 143

• Installing a Double-High, Double-Wide Gigabit-Backplane Physical Interface Module

on the SRX Series Services Gateway on page 27

Chapter 15: 24-Port Gigabit Ethernet XPIM

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 263 264

Pas de commentaire

Juniper 1-Port Serial Mini-PIM Spécifications Page 165