• 2-Port 10 Gigabit Ethernet XPIM Components on page 114
• 2-Port 10 Gigabit Ethernet XPIM Basic Configuration on page 115
2-Port 10 Gigabit Ethernet XPIM Components
The 2-Port 10 Gigabit Ethernet XPIM contains the components listed in Table 46 on
page 114.
Table 46: 2-Port 10 Gigabit Ethernet XPIM Components
DescriptionLocationComponent
Use the XPIM
ONLINE/OFFLINE button to
gracefully shut down the XPIM.
Right side of the XPIMXPIM ONLINE/OFFLINE button
Only SRX650 Services
Gateway supports
hot-swappable functionality
for GPIMs.
•
Copper ports support link
speeds of 10/100/1000
Mbps/10 G in full-duplex
and half-duplex modes.
•
Fiber ports support link
speeds of 1000 Mbps/10 G
in full-duplex mode.
NOTE: The 1 G fiber port
configuration is supported
starting with Junos OS Release
10.2R2.
•
Copper ports (for 10 G) use
a CAT-6a or CAT-7 cable
connector.
•
Copper ports support
autonegotiation; whereas
fiber ports do not support
autonegotiation.
NOTE: The 10 G fiber port
does not support
autonegotiation.
•
All ports support flow
control and can be
configured in loopback
mode for testing purposes.
Middle of the XPIMTwo groups of ports labeled 0
and 1, where each group
contains 1 copper port and 1
fiber port.
NOTE: By default, all ports are
flow control enabled, and
support link speed of 10 G in
full-duplex mode.
The 10 G fiber port does not
support autonegotiation.
Use the fiber ports to connect
various SFP+ transceivers for
fiber cable connections. See
Table 47 on page 115 for
supported SFP+ transceivers.
Use the captive screws to hold
the XPIM in place.
One on each side of the XPIMCaptive screws
You can customize the Ethernet interface type by using different SFP+ transceivers. Table
47 on page 115 shows the available SFP+ transceivers.
Copyright © 2012, Juniper Networks, Inc.114
SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide
Commentaires sur ces manuels