Table 59: 24-Port Gigabit Ethernet XPIM Components (continued)
DescriptionLocationComponent
NOTE: Each port on the
24-Port Gigabit Ethernet with
PoE XPIM supports Power over
Ethernet (PoE).
Each Gigabit Ethernet port:
•
Provides link speeds of
10/100/1000 Mbps
•
Uses an RJ-45 connector
•
Operates in full-duplex and
half-duplex modes
•
Supports flow control
•
Supports autonegotiation
Middle of the XPIM24 fixed Gigabit Ethernet ports
labeled 0–23
NOTE: The 24-Port Gigabit
Ethernet with PoE XPIM port
labels are yellow instead of
white.
NOTE: The RJ-45 and SFP
ports 20–23 are shared ports.
The SFP port will always take
priority over the corresponding
RJ-45 port if they are both
connected.
Use these ports to connect
various SFP transceivers for
fiber cable connections.
Right side of the RJ-45 ports
0–23
4 1-Gigabit small form-factor
pluggable (SFP) ports labeled
20–23
See Table 60 on page 145 for
supported SFP transceivers.
NOTE: The RJ-45 and SFP
ports 20–23 are shared ports.
The SFP port will always take
priority over the corresponding
RJ-45 port if they are both
connected.
Use the captive screws to hold
the XPIM in place.
One on each side of the XPIMCaptive screws
Use the handles to grasp the
XPIM for installation or
removal.
One on each side of the XPIMHandles
You can customize the Ethernet interface type by using different SFP transceivers. Table
60 on page 145 shows the available SFP transceivers.
NOTE: We strongly recommend the use of Juniper Networks SFP and XFP
transceivers. We cannot guarantee correct operation if other transceivers are
used. The transceiver type can be different in each port, as long as a supported
part number is used.
Copyright © 2012, Juniper Networks, Inc.144
SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide
Commentaires sur ces manuels