1-Port Serial Mini-Physical Interface Module Key Features
The 1-Port Serial Mini-Physical Interface Module (Mini-PIM) provides the following key
features:
•
Autoselection of operational modes based on DTE or DCE cables
•
Local and remote loopback diagnostics
•
Configurable clock rate for the transmit (TX) clock and receive (RX) clock
•
Complete configuration and management by using the CLI and the J-Web interface
Related
Documentation
1-Port Serial Mini-Physical Interface Module Overview on page 67•
• 1-Port Serial Mini-Physical Interface Module Hardware Specifications on page 68
• 1-Port Serial Mini-Physical Interface Module Supported Standards on page 68
• MTU Default and Maximum Values for Physical Interface Modules on page 10
• 1-Port Serial Mini-Physical Interface Module LEDs on page 69
• 1-Port Serial Mini-Physical Interface Module Basic Configuration on page 70
1-Port Serial Mini-Physical Interface Module LEDs
The 1-Port Serial Mini-Physical Interface Module (Mini-PIM) has one LED located to the
right of the serial port. Table 28 on page 69 describes the LED states.
Table 28: 1-Port Serial Mini-PIM LED States
DescriptionStateColorName
Online with no alarms or failures.OnGreenSTATUS
Device has detected a failure.Off
Related
Documentation
1-Port Serial Mini-Physical Interface Module Overview on page 67•
• 1-Port Serial Mini-Physical Interface Module Hardware Specifications on page 68
• 1-Port Serial Mini-Physical Interface Module Supported Standards on page 68
• 1-Port Serial Mini-Physical Interface Module Key Features on page 69
• 1-Port Serial Mini-Physical Interface Module Basic Configuration on page 70
1-Port Serial Mini-Physical Interface Module Interface Cables
Table 29 on page 70 lists the cables that you can order from Juniper Networks to connect
to a port on the synchronous 1-Port Serial Mini-Physical Interface Module (Mini-PIM).
69Copyright © 2012, Juniper Networks, Inc.
Chapter 7: 1-Port Serial Mini-Physical Interface Module
Commentaires sur ces manuels