•
Verify that the Dual CT1/E1 GPIM is installed on the services gateway:
show chassis hardware
•
Verify the FPC status of the interface:
show chassis fpc
•
Configure the parent CE1 interface with no partitioning:
set interfaces ce1-3/0/0 no-partition interface-type e1
•
Configure the child E1 interface and assign an IP address:
set interfaces e1-3/0/0 unit 0 family inet address ip4–address/prefix
•
Assign MTU values to the child E1 interface:
set interfaces e1-3/0/0 unit 0 mtu mtu values
•
Configure a security zone for the child E1 interface and set the configuration for host
inbound traffic services and protocols:
set security zones security-zone trust interfaces e1-3/0/0 host-inbound-traffic
system-services all
set security zones security-zone trust interfaces e1-3/0/0 host-inbound-traffic protocols
all
•
Set security policies:
set security policies default-policy permit-all
Related
Documentation
• Dual CT1/E1 GPIM Overview on page 149
• Dual CT1/E1 GPIM Key Features on page 150
• Dual CT1/E1 GPIM Network Interface Specifications on page 151
• Dual CT1/E1 GPIM Hardware Specifications on page 151
• Dual CT1/E1 GPIM LEDs on page 152
• Dual CT1/E1 GPIM Components on page 153
• Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services
Gateway on page 24
Copyright © 2012, Juniper Networks, Inc.156
SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide
Commentaires sur ces manuels