Juniper WLA522E Guide d'installation télécharger pdf (Page 31)

Wireless LAN Access Point WLA522 and WLA522E Quick Start Guide Part Number: 530-042353 Rev.01

Connecting an AP to an WLC

You can connect an AP directly to an WLC or indirectly to the WLC through an intermediate Layer 2 or Layer 3

network. If you are connecting the AP directly to an WLC, use the following procedure to insert the cable into

the WLC and verify the link.

You can use the CLI or RingMaster to configure an AP connection. If you are installing the AP as a Mesh AP in

a WLAN Mesh or wireless bridge configuration, you must configure the AP connection before deploying the AP

in the final location. (See the Mobility System Software Configuration Guide.)

Figure 31 below shows how to insert a Cat 5 cable into 10/100 Ethernet port on an WLC. Refer to this figure as

you perform the procedure.

Figure 31: 10/100 Cat 5 Cable Installation

1. Insert a Cat 5 cable with a standard RJ-45 connector. For connection to an AP, use a straight-through

cable.

2. When the link is activated, observe the AP LED for the port on the WLC.

Mobility Exchange

MX-20

Ethernet cable

(Cat 5 cable)

AP, WLC, server

or other device

Ethernet port

1 2 ... 26 27 28 29 30 31 32

Pas de commentaire

Juniper WLA522E Guide d'installation Page 31