Juniper DPCE-R-Q-40GE-SFP Fiche technique télécharger pdf (Page 46)

•

Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45 connector

•

Pinout:

•

Junos OS Release 9.1: MDI

•

Junos OS Release 9.2 and later: MDI, MDI crossover

•

Maximum distance: 328 ft/100 m

CAUTION: Do not use RJ-45 cables with strain-relief boots exceeding 1.5 mm from the bottom

of the connector. Cable boots that exceed this measurement can damage the port.

Cables and connectors

OK/FAIL LED, one bicolor:

•

Steady green—DPC is functioning normally.

•

Blinking green—DPC is transitioning online or offline.

•

Red—DPC has failed.

ACT LED, one green per port:

•

Off—No active traffic.

•

Blinking—Link is active.

SPD LED, one bicolor:

•

Green—DPC is functioning in 1000BASE-T mode.

•

Yellow—DPC is functioning in 10BASE-T or 100BASE-TX mode.

•

Off—No link.

The ACT and SPD LEDs are located on either side of the ports labeled horizontally and top to

bottom 0/0 through 3/9.

LEDs

Documentation

MX Series DPC Overview on page 4•

• DPCs Supported on MX240, MX480, and MX960 Routers on page 6

MX Series 3D Universal Edge Routers Line Card Guide

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 197 198

Pas de commentaire

Juniper DPCE-R-Q-40GE-SFP Fiche technique Page 46